Blackberry RADAR-M ITA100-1 설치 매뉴얼 - 페이지 36

{카테고리_이름} Blackberry RADAR-M ITA100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR-M ITA100-1 39 페이지. Container, dry van, insulated trailers barn doors
Blackberry RADAR-M ITA100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (27 페이지), 설치 매뉴얼 (36 페이지)

페이지 인쇄

BLACKBERRY RADAR ITA100-1 CHASSIS BRACKET INSTALLATION GUIDE

5. Remove the screws from the device.

Tip: For faster screw removal, you may use a T-30 Torx bit on a cordless drill.

6. Remove the internal module from the bracket. Guide the device along the cable and

the connector through the hole on the internal module.

7. Separate the external module from the bracket using the following technique.

IMPORTANT: Do not attempt to separate the device from the bracket using

a heat gun. This can damage the device.

Avoid striking the device with a hammer. Repeated strikes with a tool can

damage the device.

At the bottom corners of the external module, insert a tool between the back of the

external module gasket and the bracket surface. Apply gentle upward pressure on the

tool to separate the module from the bracket. Repeat until external module is separated

from the bracket. When using this approach, please exercise caution to avoid greatly

damaging the sealing gasket.