Aleko AR 900 사용자 설명서 - 페이지 8

{카테고리_이름} Aleko AR 900에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko AR 900 16 페이지. Sliding gate operator

* Before starting installation, ensure that there is no point of friction during the entire movement of

the gate and there is no danger of derailment.

* Ensure that the Warning Signs are present.

Necessary Tools: The following tools may be necessary to install the Gate operator. You will need

screwdrivers, an electric drill, wire cutters and a wire stripper, a socket set, and possibly access to a

welder.

When install the operator, you should build a concrete pad to support the base plate of operator in order to

maintain proper stability.

The installation proceeds are as follows:

1.Dig a hole for a concrete pad which

should be approximately 50 x 32 x

35cm (20 〞 x 13 〞 x 14 〞 ). It may

protrude 10 cm (4") above ground and

25 cm (10") in depth underground.

Increase the pad height if necessary to

protect the system from flooding, heavy

snow etc.

2. Prepare one or more conduits for the

electrical cables before pour concrete.

Remember that cable conduits have to

pass through the hole in the base plate.

3. Pour concrete and before it starts to

harden, check that it is parallel to the

gate leaf and perfectly level.

4. Mark the position of four expansion

anchors according to the position of

mounting hole on the base plate as

soon as concrete become harden.

Double check your marking, move the

base plate and drill the 4 holes using a

10mm (3/8") masonry bit. Put the 4

expansion anchors (provided) into the

holes and firmly tighten.

5. Place the opener onto base plate. Check that it is perfectly parallel to the gate leaf, and then screw the

four bolts and washers supplied. It's only temporary installation. Further adjustment will be required when

install the rack.

Manual Operation

The operator should be put in the manual (emergency release) position before fitting the rack, installing the

operator and limit switch. The process is as follows:

1) Take of the rubber stopple.

2) Insert the Release Key （ provided） and turn it in counter-clockwise 90° to disengage the clutch between the

gear shaft and power output. Now the operator is in the manual operation.