Clarke Contractor CROS2 운영 및 유지 관리 지침 - 페이지 4
{카테고리_이름} Clarke Contractor CROS2에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Contractor CROS2 12 페이지. Random orbital sander
페이지 인쇄
16. ALWAYS have your power tool serviced by a qualified repair
person using only identical replacement parts. This will ensure
that the safety of the power tool is maintained.
17. NEVER operate machine while under the influence of drugs,
alcohol or any medication.
18. NEVER leave machine running unattended.
19. NEVER force the machine. It will do a better and safer job at
the rate for which it was designed.
20. NEVER use power tools in damp or wet locations or expose
them to rain.
21. NEVER operate power tools in explosive atmospheres, such as
in the presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
ADDITIONAL PRECAUTIONS FOR POWER TOOLS
1.
ALWAYS wear ear protectors/defenders as the noise level of this machine can
exceed 85dB (A).
2.
ALWAYS use the appropriate sanding sheet for the material being worked.
3.
ALWAYS keep the mains cable well away from the machine and ensure an adequate
electrical supply is close at hand so that the operation is not restricted by the length
of the cable.
4.
ALWAYS use extreme caution when using power tools, avoid contact with earthed or
grounded surfaces (e.g. pipes radiators etc).
5.
ALWAYS switch the machine OFF immediately the task is completed.
6.
ALWAYS use secure the workpiece using clamps or vice etc.
7.
ALWAYS store idle tools safely out of the reach of children in a dry location, preferably
locked away in a cupboard etc.
8.
NEVER allow the ventilation slots in the machine to become blocked.
9.
DO NOT exert pressure on sander to stop it quickly, allow it to stop normally.
10. DO NOT use the machine if the electric cable, plug or motor is in poor condition.
Additionally, please keep these instructions in a safe place for future reference.
Dust extraction
The sander is provided with a dust extraction facility, Please note however, that this does
not preclude the user from wearing a face mask to prevent the inhalation of dust
particles.
It is an EEC requirement that a dust extraction facility be provided on power tools, however,
due to the nature of the tool, some of the dust produced will be forced into the surrounding
atmosphere, and will not be collected.
4