Clarke CROS1 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke CROS1에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CROS1 12 페이지. Rotary orbital sander
Clarke CROS1에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (13 페이지)

페이지 인쇄

Operation

Fitting Sanding Disk.

a) Select disk to be used. (MUST be correct disks with velcro fitting ability).

b) Ensure sander is switched OFF and plug is removed from socket.

c) Line up holes in disk with those on machine pad. (This is necessary for dust

extraction), press disk firmly onto pad to secure it.

Handgrips.

Your sander is fitted with two handgrips to ensure full control of the machine.

a) Fixed handgrip (handle) with ON/OFF switch and power cable.

b) Adjustable support grip. This can be adjusted for position by loosening handgrip

slightly, (unscrew anticlockwise) and rotating handgrip around body of machine,

to desired position, then tighten securely, hand tight only.

Dust Collection.

The dust collection bag is fitted by simply inserting assy into the waste duct bellow

the ON/OFF switch.

Note :

Dust bag must be emptied regularly, do not wait until it is completely full.

Dust bag is emptied as follows.

a) Ensure sander is switched OFF and isolated by removing plug from socket.

b) Gently remove dust bag assy from sander by turning whilst pulling.

c) Take dust bag assy to dustbin and slip bag off, (bag has elasticated top), empty

bag into bin.

d) Reassemble dust bag assy and fit back on to sander.

To operate, insert the plug into the mains socket and switch on, holding sander firmly with

both hands depress ON/Off switch located below handle, variable speed is achieved by

depressing the switch fully for maximum speed or less for slower speed.

To control the speed so that it remains constant, turn the knob located on the switch in the

direction marked, i.e. - = lower speed + = higher speed.

The ON/Off switch can be locked for continuous sanding once depressed, to release the

switch, just depress again and release, (motor will stop).

Once machine has reached required speed, offer disk to workpiece and work gently

backwards and forwards across work until finished, remove sander from workpiece and

release switch, (wait until motor has stopped fully before putting tool down).

Maintenance

Always inspect the tool before use, and ensure it is in top condition.

Ensure all air vents are clear, (use compressed air to clean the machine where possible).

Check the power cable to ensure it is sound and free from cracks, bare wires etc. avoid

using solvents when cleaning plastic parts, most plastics are susceptible to damage from

the various types of commercial solvents.

All bearings etc., in this tool are lubricated with a sufficient amount of high grade lubricant

for the tools lifetime under normal operating conditions, therefore no further lubrication is

required.

-6-