Clarke DWS180 운영 및 유지보수 지침 매뉴얼 - 페이지 12

{카테고리_이름} Clarke DWS180에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DWS180 17 페이지. Hand held drywall sander

LED LIGHT

1. Adjust light to appropriate angle

2. The light has an independent On/

Off button.

Both carbon brushes need replacing

once either have less than 6mm

length of carbon remaining.

1. Ensure the sander is switched off

and the plug is removed from the

socket.

2. Unscrew the plastic caps (1&2)

found towards the rear of the

motor housing on both sides. Be

careful as the caps are spring

loaded.

3. Withdraw the brush with its spring.

4. If replacement is necessary,

renew the brush and replace the

cap.

5. Ensure the cap screws back freely

• ALWAYS inspect the sander before use and ensure it is in working

condition.

• Ensure all air vents are clear. (Use vacuum cleaner to clean the

machine where possible).

• Check the power cable to ensure it is sound and free from cracks,

bare wires etc. Avoid using solvents when cleaning plastic parts,

(most plastics are susceptible to damage from the various types of

commercial solvents).

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]