Clarke METALWORKER CBB200E 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke METALWORKER CBB200E에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke METALWORKER CBB200E 13 페이지. 550w buffer/polisher

USING YOUR BUFFER/POLISHER

WARNING: BEFORE COMMENCING WORK, ENSURE YOU HAVE READ AND

UNDERSTOOD ALL OF THE SAFETY INSTRUCTIONS

1. Plug the buffer/polisher into the mains power supply.

2. Switch the buffer/polisher on

3. Slowly bring the workpiece into

contact with the polishing mop.

• See the image on the right to

determine the safest and best

position for contact with the

wheel.

• DO NOT contact the wheel

outside of the quadrant.

4. After use, unplug the buffer/polisher from the power supply, and clean the

machine ready for next use.

MAINTENANCE

WARNING: MAKE SURE THAT THE BUFFER/POLISHER IS UNPLUGGED FROM

THE MAINS POWER SUPPLY BEFORE PERFORMING ANY MAINTENANCE.

1. Regularly inspect the buffing/polishing pad and replace when worn.

2. The motor and bearings are sealed units and require no maintenance.

CLEANING

1. Keep the machine clean and dry. DO NOT use abrasives.

2. Clean the exterior the machine if required using a mild detergent or mild

solvent.

3. Never immerse the machine in water.

4. Keep any cooling vents free of debris.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]