Clarke METALWORKER CBB200E 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke METALWORKER CBB200E에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke METALWORKER CBB200E 13 페이지. 550w buffer/polisher

ASSEMBLY

MOUNTING THE MACHINE

1. Bolt the buffer/polisher to a

workbench using the securing holes

shown.

• Check that all assembly nuts

and bolts are secure before

turning the machine on.

FITTING BUFFING/POLISHING PADS

1. Place the spacer over the shaft.

2. Place the polishing mop between the washers and secure with the retaining

nut, hand tight.

• The shaft threaded ends are handed LH and RH.

3. Tighten the nuts enough to grip without crushing the buffing/polishing pad.

NOTE: Wheel rotation, in use, will tighten the retaining nut.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]