Clarke Woodworker CDS300 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Clarke Woodworker CDS300에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CDS300 12 페이지. 300mm disc sander

ADDITIONAL SAFETY INSTRUCTIONS for DISC SANDERS

✔

ALWAYS place the sander on a solid wood workbench which will not

move under load.

✔

ALWAYS wear safety goggles as protection against flying grit and/or

sawdust. In many cases, a full face shield is even better protection. A

dust mask is also recommended to keep saw dust out of your lungs.

✔

ALWAYS clear the work table of all objects except the workpiece (tools,

scraps, rulers etc.) before switching on the sander.

✔

ALWAYS keep your fingers well away from the disc.

✔

ALWAYS switch off the sander, and make sure the disc has come to a

complete stop before clearing sawdust from the table.

✔

ALWAYS make sure there are no nails or foreign objects in the part of

the workpiece to be sanded.

✔

ALWAYS set up the machine and make all adjustments with the power

OFF, and disconnected from the supply.

✔

ALWAYS use the correct type and size of sanding disc for each

operation.

✔

ALWAYS maintain a gap of 1.5 - 2mm MAX. between the sanding Disc

and the table.

✔

ALWAYS take great care if sanding non-ferrous metals. Dust from some

materials can be extremely dangerous.....toxic or explosive.

✘

NEVER operate the machine with the guards or table removed. They

must all be in place and securely fastened when performing any

operation

✘

NEVER sand any material that does not have a flat surface on which

to bear.

✘

NEVER force the work into the disc....Hold it FIRMLY and press it gently

into the disc, on the DOWNWARD direction side.

NOTE: The disc spins in an ANTICLOCKWISE direction. The workpiece

should ALWAYS be sanded on the LEFT HAND HALF of the disc.