Clarke Woodworker CDS300 Operating & Maintenance Manual - Page 6
Browse online or download pdf Operating & Maintenance Manual for Sander Clarke Woodworker CDS300. Clarke Woodworker CDS300 12 pages. 300mm disc sander
Print Page
ADDITIONAL SAFETY INSTRUCTIONS for DISC SANDERS
✔
ALWAYS place the sander on a solid wood workbench which will not
move under load.
✔
ALWAYS wear safety goggles as protection against flying grit and/or
sawdust. In many cases, a full face shield is even better protection. A
dust mask is also recommended to keep saw dust out of your lungs.
✔
ALWAYS clear the work table of all objects except the workpiece (tools,
scraps, rulers etc.) before switching on the sander.
✔
ALWAYS keep your fingers well away from the disc.
✔
ALWAYS switch off the sander, and make sure the disc has come to a
complete stop before clearing sawdust from the table.
✔
ALWAYS make sure there are no nails or foreign objects in the part of
the workpiece to be sanded.
✔
ALWAYS set up the machine and make all adjustments with the power
OFF, and disconnected from the supply.
✔
ALWAYS use the correct type and size of sanding disc for each
operation.
✔
ALWAYS maintain a gap of 1.5 - 2mm MAX. between the sanding Disc
and the table.
✔
ALWAYS take great care if sanding non-ferrous metals. Dust from some
materials can be extremely dangerous.....toxic or explosive.
✘
NEVER operate the machine with the guards or table removed. They
must all be in place and securely fastened when performing any
operation
✘
NEVER sand any material that does not have a flat surface on which
to bear.
✘
NEVER force the work into the disc....Hold it FIRMLY and press it gently
into the disc, on the DOWNWARD direction side.
NOTE: The disc spins in an ANTICLOCKWISE direction. The workpiece
should ALWAYS be sanded on the LEFT HAND HALF of the disc.
6