Directed Electronics 3100 설치 매뉴얼 - 페이지 10

{카테고리_이름} Directed Electronics 3100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 3100 16 페이지. Car security

Remote Control Programming

Remote controls included in this system are pre-programmed in the standard

button configuration, and are ready to use. This system will accept up to four

remote controls.

To add, delete, or reprogram remote controls with customized button configura-

tions, use the following procedure.

Important: Test the systems Ignition input, Door trigger input, Valet button,

Status LED, and siren for proper operation before proceeding.

Select a System Function and the required number of valet button presses,

as described in the following table. (see Function description table)

Open a door and turn the key ON (run position).

Press and release the Valet button to select the function. After pressing

and releasing corresponding to the function, then press the Valet button

once more and hold it. The LED flashes and the siren sounds to confirm

the selection.

While holding the Valet button, press the remote button that controls the

selected function. The siren emits one long sound to confirm program-

ming.

Release the Valet button to finish and exit programming, or to program

another function return to step 3 and continue through step 5 again (Ex-

ample: after programming 'Arm only', select 'Panic only' by pressing and

releasing the Valet button two times, then press and hold it). Repeat to

program more functions.

Exit Programming

The siren emits one quick chirp, and then another lengthier chirp when exiting.

Programming is exited if any of the following occurs:

•

Turn ignition off

•

Close the doors

•

Press Valet button too many times

•

15 seconds or more lapses between steps