Clarke 7120400 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke 7120400에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7120400 17 페이지. 1.5” electric water pump

MAINTENANCE

Inspect the pump/hoses regularly to ensure that debris is not blocking the

passage of water.

If you suspect the pump is blocked by silt, leaf debris etc, disconnect it from

the power supply, disconnect the discharge hose and back-flush to clear any

blockage using a hosepipe.

Always keep the pump in a clean condition and check regularly for damage

to the power cable etc.

AFTER USE

After use, and if the pump will not be used over the winter period, or if there is

danger of freezing, always drain the pump body.

If the pump has been used with contaminated or salty water, it should be

thoroughly flushed with clean water following use, both inside and out. It

should then be drained and covered over, if not already sheltered from the

weather.

If the pump is seized following a period of inactivity, it may be possible to free

it off. Ensure the pump power supply is turned off before by inserting a

screwdriver into either the infeed or discharge port and dislodging a jammed

impeller. If this is not successful it may be necessary to remove the relevant

mounting bolts to separate the pump body and clean away any incrustation.

Re-prime the pump when returning to service.

• In the event that overhaul of the pump or motor is necessary,

contact your Clarke service department.

Through purchase of this product, the customer is taking on the

obligation to deal with the WEEE in accordance with the WEEE

regulations in relation to the treatment, recycling & recovery and

environmentally sound disposal of the WEEE.

In effect, this means that this product must not be disposed of with general

household waste. It must be disposed of according to the laws governing

Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal

facility.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]