Clarke 7120400 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke 7120400에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7120400 17 페이지. 1.5” electric water pump

PRIMING THE PUMP

Before using the pump for the first

time the inlet (suction) side must be

filled with water to prime the pump as

follows:-

1. With all inlet pipes/hoses, but no

outlet hose connected, pour

water into the outlet port until all

the air is expelled.

2. Connect the outlet hose to the

outlet port.

If the outlet hose is already connected, a priming port and threaded plug are

provided, adjacent to the outlet as shown.

NOTE: As the priming hole is quite small, it is recommended to fill the inlet

(suction) pipe with water before connecting to the pump, and

top up through the priming port once the pipe is connected. A

non-return valve will need to be fitted to the inlet pipe for this

purpose.

3. Switch on the pump.

• Water should start to flow through the system.

4. Check for leaks and make good if necessary.

5. Adjust any device such as a non-return valve, which may be fitted to the

outlet side of the pump, to maximise efficiency.

• Do not place any restriction on the inlet or discharge hoses.

• Remember - this pump is designed for pumping CLEAN WATER ONLY.

DO NOT USE for pumping chemicals or other flammable or corrosive

liquids.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]