Directed Electronics 556U 매뉴얼 - 페이지 3

{카테고리_이름} Directed Electronics 556U에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 556U 10 페이지. Immobilizer interface

S S t t a a n n d d a a r r d d I I m m m m o o b b i i l l i i z z e e r r I I n n t t e e r r f f a a c c e e

1. Open the control module and place the vehicle's coded key through the center of the black receiver ring as shown.

2. Reassemble the control module. This will secure the key inside.

I I M M P P O O R R T T A A N N T T ! ! When using the ring method of installing the 556U, the ring from the 556U MUST

be in front of the factory receiver ring. It CAN NOT be on top of, or behind the factory receiver

ring. See illustration below.

3. Disassemble the steering column shroud and place the antenna ring around the vehicle's ignition switch as

shown, and plug into the control module.

4. Plug the 6-pin power plug into the control module.

5. Connect the BLACK wire to chassis (ground).

6. Connect the red wire to a fused source of constant 12V.

7. Connect the blue wire to the status output (blue wire) of the remote start system that provides a latched

negative (-) ground while the remote start is active.

8. Test unit before reassembling the steering column.

9. Reassemble the steering column shroud.

3 3

N556U 09/04