Directed Electronics 556U 매뉴얼 - 페이지 7

{카테고리_이름} Directed Electronics 556U에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 556U 10 페이지. Immobilizer interface

페이지 인쇄

A A l l t t e e r r n n a a t t e e I I m m m m o o b b i i l l i i z z e e r r I I n n t t e e r r f f a a c c e e N N o o . . 2 2

This type of interface will only work with immobilizer systems that have a two-wire factory antenna harness. This

alternate interface method is not guaranteed to work with all immobilizer systems, due to differences in

transponder systems. It is meant to provide the installer with an alternative interface method for most two-wire

transponder ring systems. T T h h i i s s m m e e t t h h o o d d w w i i l l l l w w o o r r k k o o n n E E u u r r o o p p e e a a n n v v e e h h i i c c l l e e s s . .

1. Open the control module and place the vehicle's coded key through the center of the black receiver ring as shown.

2. Reassemble the control module to secure the key inside.

3. Disassemble the steering column shroud and locate the factory transponder ring's antenna wires. The two

wires are usually located in a tube routing from the transponder ring to the factory transceiver module.

N N O O T T E E : : Some vehicles may require other methods to access the factory transponder ring antenna

wires.

7 7

N556U 09/04