Clarke 7230693 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 7230693에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7230693 13 페이지. 250w puddle pump with auto sensor

ASSEMBLY

Remove all packaging and make sure that the unit has no visible damage.

Dispose of all packaging appropriately.

FITTING THE ELBOW

1. Screw the elbow into the outlet

port as shown.

2. Connect a suitable hose (not

supplied) to the pump outlet.

• Suitable hoses are available

from your local Clarke dealer.

The 3 step hose adaptor can be

screwed onto the elbow if required.

1. Fit the supplied non return valve

between the adaptor and the

elbow.

2. Trim the adaptor to the required

size.

3. Connect your hose (not supplied)

NOTE: Reducing the hose diameter will effect the maximum flow rate.

This pump has an Automatic Sensor

function. This activates the pump

when the water level sensor is

immersed.

1. The sensor can be 'parked' in one

of three positions (High Medium,

Low) on the pump as shown.

2. The pump will run until the water

level drops below the sensor,.

• The pump continues to run for a further 3 minutes and then stops.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]