Alemite 7818-F4 서비스 매뉴얼 - 페이지 14

{카테고리_이름} Alemite 7818-F4에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 7818-F4 16 페이지. Pump hoist and power ram

SER 7818-F5

1. Install Block-V Packings (17) onto Piston

(18).

• See Figure 5 for the proper orientation of

the Packings.

2. Install and seat Gasket (16), the Piston

assembly, additional Gasket (16), and

Spacer (15) onto Bolt (19).

3. Screw the Bolt assembly into Piston Rod

(8).

• Tighten the Bolt securely.

4. Install and center Pin (9) in the Piston Rod.

CAUTION

Use care during the installation of the

Piston assembly. Damage to the Block-V

Packings can occur.

5. Install the Piston assembly into Column

(20).

6. Install O-Ring (14) onto Bushing (13).

7. Install the Bushing assembly onto the

Piston and into the Column.

8. Install Block-V Packing (12) [lips

downward] and Washer (11) over the Piston

and into the Bushing.

• Use care passing the cross-hole in the

Piston.

• Make sure both components seat properly

within the Bushing.

9. Screw Cap (10) onto the Column.

• Tighten the Cap securely.

10. Install the Bridge assembly onto each

Piston Rod.

• Make sure the pin holes are in alignment.

11. Install Roll Pins (6) that secure the Piston

Rods to Bridge (5).

Revision (6-04)

1-800-548-1191-http://[email protected]

Refer to Figure 2-A Parts List

for Parts Identification

Figure 5 Hoist Column- Section View

Pump Hoist and Power Ram

Alemite Corporation