Alemite 7818-F4 서비스 매뉴얼 - 페이지 15

{카테고리_이름} Alemite 7818-F4에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 7818-F4 16 페이지. Pump hoist and power ram

Pump Hoist and Power Ram

Follower Plate

Assembly

Hoses to Follower Plate

NOTE: Refer to Figure 2-E for component

identification on the following procedures.

1. Insert Clamp (81) into upper Hose (83).

IMPORTANT: Hose (83) is slightly longer

than lower Hose (82).

2. Coil the Hose assembly into the upper groove of

Follower Plate (78).

HINT: Position the Follower Plate assembly

on its outer circumference with the Clamp

opening upward.

Alemite Corporation

1-800-548-1191-http://[email protected]

Changes Since Last Printing

Deleted Pump Models 7785-B5 and 7786-C from Table 1

3. Draw the Clamp tight against the Hose and Follower

Plate.

4. Close the opening in the Hose.

• Hammer the Hose with a wooden or rubber mallet.

• Make sure the ends butt squarely.

5. Repeat steps 1 through 4 for lower Hose (82).

IMPORTANT: Make sure the opening on the

Lower Hose is 180 ° opposite the upper

Hose.

SER 7818-F5

Revision (6-04)