Alemite 8301 서비스 지침 매뉴얼 - 페이지 2
{카테고리_이름} Alemite 8301에 대한 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 8301 11 페이지. Air-operated double diaphragm pump
Alemite 8301에 대해서도 마찬가지입니다: 서비스 및 운영 매뉴얼 (10 페이지)
페이지 인쇄
SER 8301
4. Never point the dispensing device at anyone.
Accidental discharge can cause serious injury.
5. Shut off the air pressure and relieve all material
pressures before attempting to service any part.
6. Check for leaks before starting any pumping
operation. If any leaks or other abnormalities are
found, do not operate the pump.
7. Wear safety glasses at all times when operating
the pump.
8. Wear a face shield and proper body protection
when working with hazardous chemicals.
9. When pumping Class 1 Hazardous (flammable)
liquids, use pump outdoors or in an OSHA approved
location.
10. When pump is used with flammable or Class 1 ma-
terials, the following procedures must be strictly applied:
A. A special "static hose" must be used which has
a provision for conducting static electrical charges.
B. Hose must be properly grounded with a
grounding conductor.
C. Pump and entire system must be properly
grounded, in accordance with local and national
codes.
WARNING: Unless proper grounding is followed,
static discharge can cause a fire or an explosion.
INSTALLATION
There are many possible configurations in which the
pump can be connected. Specific installations will
depend on the fluid being pumped and the application.
NOTE: For best results, it is recommended that an
air filter/moisture separator (such as the Alemite
5604-2) and an air-pressure regulator (such as the
Alemite 7604-B) be used in the air line.
WARNING: The pump must be grounded to prevent
any sparks when pumping flammable or volatile liquids.
NOTE: The inlet and outlet manifolds are reversible
to facilitate connecting the hoses from either
direction.
1. Connect a suction hose from the supply container
to the pump fluid inlet.
2. Connect a discharge hose to the pump fluid outlet.
page 2
8-7/8
Fluid
Outlet
1/2" NPT
8-7/32
Fluid
Inlet
1/2" NPT
2-3/32
2-17/32
5-29/32
Air
Exhaust
3/8" NPT
4-29/32
3-29/32—4-15/16
7-3/32
Figure 2: Dimensions & Locations
11-29/32
4-7/8
Air
Supply
1/4" NPT
7-5/16
page revised 6-03