Clarke CEB102 운영 및 유지 관리 지침 - 페이지 2
{카테고리_이름} Clarke CEB102에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CEB102 4 페이지. Non-submersible water pump
페이지 인쇄
T
hank you for purchasing this CLARKE Water Pump, which is a general purpose
pump, suitable for a variety of applications involving the transfer of clean, cold
water ONLY.
The CEB101 differs from the TAM 100 model in that it has a brass body designed for
longer life, and an increased resistance to corrosion.
To help ensure long, trouble free performance and the protection afforded by
the warranty, please follow carefully all the instructions and recommendations
given in this booklet.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered
with in any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase. No product can be
returned to us without prior permission. This guarantee does not effect your
statutory rights.
SAFETY PRECAUTIONS
1.
Ensure the pump is installed in a horizontal position with the outlet facing
vertically upwards, and that it is firmly anchored via its fixing screws.
2.
Ensure there is an adequate air flow around the pump. DO NOT mount it in an
enclosed atmosphere.
3.
Ensure all water pipes - supply or discharge, are adequately supported where
necessary, so as not to put a strain on the pump connections.
4.
DO NOT allow the pump to run dry, as this will cause serious damage to the
pump seals.
5.
Ensure the inlet to the pump is completely unrestricted.
6.
Ensure the pump is protected from the elements, neither the motor nor the
electrical terminal box is intended to be waterproof.
7.
Ensure that all pipes are protected against damage where necessary, and
that they are suitably lagged to avoid the possibility of freezing during cold
weather.
8.
DO NOT attempt to pump water when the ambient temperature is greater
than 40ºC or the water temperature is greater than 40ºC or less than 0ºC.
9.
DO NOT use this pump for pumping anything other than CLEAN WATER
10. DO NOT wrap the pump motor or pump head in cold conditions in the
mistaken belief that this will stop the pump from freezing.
11. ALWAYS install a foot valve/filter when lifting water (suction lifting), Foot filters
are available from your CLARKE dealer.
2
Description
Part No
1
Bolt
7G01
2
Pump Body TAM 101
ZG02Cl
2
Pump Body CEB1O2
ZG02B
3
Priming Plug
7G03
4
Washer
ZG04
5
Impeller
ZG05
6
Locking Ring
7G06
7
Front Cover TAM 101
ZG07Cl
7
Front Cover CEB1O2
ZG07B
8
Rotor
ZG08
9
Ball Bearing
ZG09
10
Key
ZG10
11
Main Body
ZG11
Description
Part No
12
Stator Compl.
ZG12
13
Stator Coil
ZG13
14
Connection Wire
ZG14
15
Motor End Cover
ZG15
16
Spring Washer
ZG16
17
Bolt
ZG17
18
Mechanical Seal
7G18
19
Fan
ZG19
20
Fan Cover
ZG20
21
Terminal Cover
ZH21
22
Terminal Block
ZG22
23
Capacitor
ZG23
24
Screw
ZG24
7