Clarke CEB103 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CEB103에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CEB103 13 페이지. Water pump

1. The suction hose and connections including the filler plug need to be

completely air tight, otherwise air will be drawn in and either reduce or

completely stop the flow of water.

2. Ensure that the system has been fully primed with water up to the level of

the filler plug.

3. Check to see that no foreign matter is fouling the intake system and check

the filter is not blocked or obstructed.

4. Check that the vertical height between the level of the water intake and

the ultimate discharge point does not exceed 35 metres. If this should be

the case then the height must be reduced.

Should you still experience problems, then contact your Clarke dealer, or

CLARKE International Service Department for advice.

ACCESSORIES

1" Foot Valve Filter

1" BSP Spigot Hose Connector

1" I.D. Reinforced Hose for suction and delivery.

1" I.D. Layflat Hose for delivery only.

SPECIFICATIONS

Motor

Max. Head

Max. Suction Lift

IP Rating

Max. Temperature or liquid being pumped

Bore Size

Max. Output

Guaranteed Sound Power Level LWA

Duty Cycle

Weight

Please note that the details and specifications contained herein, are correct at the time

of going to print. However, CLARKE International reserve the right to change

specifications at any time without prior notice. Always consult the pump's data plate

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

370W, 230V 50Hz 1ph

35 m

8 m

IPx4

1"BSP

35 litres/min

77 dB

S1 - Continuous

5.4 kg

7950561

7950210

7955010

7955110