Clarke CRWP1 운영 지침 - 페이지 3

{카테고리_이름} Clarke CRWP1에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CRWP1 4 페이지. Semi-rotary hand pump

5. Connect any inlet and discharge hose connectors which are compatible

with the 1" BSP connecting flanges of the pump.

MAINTENANCE

1. Ensure that the seal compression nut (3) is sufficiently tight. If not, leakage

can take place from the pump handle shaft.

2. If using the pump for water, and there is a likelihood of freezing when not

in use, drain the pump via the access plug (15).

3. If the pump has been used for pumping any liquid likely to leave chemical

residues, it should be flushed through with clean water after use.

4. If the pump will be unused for extended periods, insert some oil through

the access plug (15) to protect the internal parts.

• Ensure the oil used does not contaminate the medium being pumped.

5. Periodically check that all nuts and bolts are tight.

A wide range of accessories are available from your nearest CLARKE dealer,

including hoses and hose adaptors and couplings.

COMPONENT PARTS

HTCRWP101 Flange Bolt & Nut

HTCRWP102 Cover Bolt & Nut

HTCRWP103 Seal Compression Nut

HTCRWP104 Wing Piston, Flap & Shaft 11.

HTCRWP105 Suction Divider, Flaps

HTCRWP106 Handle & Handle Spike

HTCRWP107 Gland Packing Set

HTCRWP108 Gland Ring

HTCRWP109 Shaft End Nut

10.

HTCRWP110 Washer

HTCRWP111 Conn Flange

12.

HTCRWP112 Casing

13.

HTCRWP113 Cover

14.

HTCRWP114 Flange Joint

15.

HTCRWP115 Access Plug