Clarke CWP1000A 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CWP1000A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CWP1000A 13 페이지. Submersible clean water pump

MAINTENANCE

WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT

IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,

ENSURE THE CIRCUIT BREAKER IS OPEN.

This pump should require no maintenance other than regular cleaning.

If the pump starts to show signs of wear or damage, contact your CLARKE

dealer for advice.

CLEANING

1. Check the pump installation regularly to ensure the water inlet is clear of

leaves or other debris.

2. Take extra care to remove any debris from around the impeller.

NOTE: Do not attempt to repair the pump yourself, as you may damage the

waterproof seal and invalidate your guarantee. Repairs must be

carried out by your CLARKE dealer, or contact the CLARKE Service

Department, on 020 8988 7400.

STORAGE

When the pump is not being used for extended periods, clean and dry it

thoroughly and store in indoors. if the pump is left in water, it must be run at

least once a week to prevent it from seizing up.

Voltage

Outlet Thread Diameter

Power

Min - Max Head Height

Maximum Depth

Maximum Flow

Maximum Water Temperature

Maximum Particle Size

Weight

Cable Length

Dimensions (D x W x H)

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

230V~50Hz

1 ½" BSP

1100W

2.4 m - 9.5 m

2 m

350 L/min

Clean Water Only

11 kg

10 m

178 x 178 x 367 mm