Clarke CWP1000A Instrukcja obsługi i konserwacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Pompa wodna Clarke CWP1000A. Clarke CWP1000A 13 stron. Submersible clean water pump
Drukuj stronę
MAINTENANCE
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,
ENSURE THE CIRCUIT BREAKER IS OPEN.
This pump should require no maintenance other than regular cleaning.
If the pump starts to show signs of wear or damage, contact your CLARKE
dealer for advice.
CLEANING
1. Check the pump installation regularly to ensure the water inlet is clear of
leaves or other debris.
2. Take extra care to remove any debris from around the impeller.
NOTE: Do not attempt to repair the pump yourself, as you may damage the
waterproof seal and invalidate your guarantee. Repairs must be
carried out by your CLARKE dealer, or contact the CLARKE Service
Department, on 020 8988 7400.
STORAGE
When the pump is not being used for extended periods, clean and dry it
thoroughly and store in indoors. if the pump is left in water, it must be run at
least once a week to prevent it from seizing up.
SPECIFICATIONS
Voltage
Outlet Thread Diameter
Power
Min - Max Head Height
Maximum Depth
Maximum Flow
Maximum Water Temperature
Maximum Particle Size
Weight
Cable Length
Dimensions (D x W x H)
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
230V~50Hz
1 ½" BSP
1100W
2.4 m - 9.5 m
2 m
350 L/min
o
40
C
Clean Water Only
11 kg
10 m
178 x 178 x 367 mm
7