Clarke DWP300A 운영 및 유지보수 지침 매뉴얼 - 페이지 4

{카테고리_이름} Clarke DWP300A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DWP300A 13 페이지. Submersible pump

SAFETY INSTRUCTIONS

GENERAL

1. Read all instructions before use and save them for future use.

2. An approved residual current device (RCD) which has a tripping current of

less then 30mA MUST be used for all operations.

3. The electrical supply must be the same as that on the rating plate.

4. ALWAYS make sure that your hands are dry when connecting or

disconnecting from the mains supply.

5. NEVER pull the mains lead to disconnect the pump from the mains socket.

6. The mains plug must be kept away from the water at all times.

7. DO NOT allow children or unauthorised people to touch the pump, cables

or connections.

8. Disconnect the pump from the mains supply when not in use.

9. If necessary have the pump repaired by a qualified person.

10. Keep the mains lead away from heat, oil and sharp edges.

11. If you have to use an extension lead with this product, it must be designed

for outdoor use and incorporate a cable suitable for use with Class I

appliances.

12. Disconnect the pump from the electrical supply and wear gloves during

servicing or maintenance.

1. Do not pump explosive / flammable liquids or chemicals.

2. NEVER allow the pump to run dry or operate out of the water.

3. Submersible pumps should always be submerged and stored vertically.

4. Disconnect the pump from the mains supply before placing it into or

removing it from the water.

5. ALWAYS check the plug, and all cables for damage before use.

6. Do not use the pump if damaged. Refer to qualified service personnel for

repair.

7. NEVER carry or lower the pump by the power cable or float switch always

use the handle or a rope tied securely to the handle.

8. NEVER insert your fingers into the pump whilst it is connected to the mains.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]