Clarke ECP20A3 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke ECP20A3에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ECP20A3 17 페이지. 2” electric water pump

ELECTRICAL CONNECTIONS

WARNING: THE INSTALLATION OF THIS APPLIANCE SHOULD BE CARRIED

OUT BY A COMPETENT ELECTRICIAN AND BE IN ACCORDANCE WITH THE

CURRENT IEE WIRING REGULATIONS (BS7671-2:2008).

This machine MUST be connected to a 400 Volt, 3 phase 50Hz supply through a

suitably fused isolator switch. It cannot be operated from a single phase

supply.

A trailing lead is provided and should be wired to a 3 phase plug (not

supplied) as follows.

• Connect the GREEN or GREEN & YELLOW

coloured wire to the terminal marked with

the letter "E" or the Earth symbol "

• Connect the remaining Brown, Black and

Grey wires to the terminals marked "L1", "L2"

and "L3".

• No connection to the Neutral terminal is

required.

Due to these high currents, the product must only be connected to a 3 phase

supply capable of supporting these loads (plus an acceptable degree of

headroom). This supply must be protected by a suitably rated circuit breaker

(or breakers) and isolator.

If in any doubt, consult a qualified electrician. DO NOT attempt any electrical

repairs yourself.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]