Directed Electronics 3000 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Directed Electronics 3000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 3000 16 페이지. Remote start system with keyless entry
Directed Electronics 3000에 대해서도 마찬가지입니다: 빠른 참조 설치 매뉴얼 (2 페이지)
페이지 인쇄•
The brake pedal is pressed.
•
The hood is opened.
•
The shutdown toggle switch is put into the OFF position
•
The pre-programmed run time has elapsed.
•
The procedure to activate remote start is repeated.
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful if you
want to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate controls on.
To perform Valet Take-Over:
1.
Before turning off the engine, send Remote Start command from
your SmartStart application.
2.
Turn the ignition key to the OFF position (The engine will stay
running).
3.
The engine will run until the pre-programmed time elapses or a
shut-down input is received. (See the previous section for a com-
plete list of shut-down inputs.)
Note: This feature will not work if the brake pedal is being pressed.
Starter Anti-Grind Circuitry
Whenever the vehicle is remote started, advanced anti-grind circuitry
prevents the starter from engaging, even if the key is turned to the start
position. This prevents damage to the starter motor if the key is turned to
the start position during remote start operation.
Note: Anti-grind circuitry only works when the remote start system is
op er at ing the motor and the optional relay is installed.
© 2010 Directed Electronics. All rights reserved.
3