Clarke JETSTAR 1700 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Clarke JETSTAR 1700에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke JETSTAR 1700 20 페이지. Ultra speed burnisher
Clarke JETSTAR 1700에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (8 페이지)

페이지 인쇄
Clarke JETSTAR 1700 운영자 매뉴얼

HOW TO CORRECT PROBLEMS IN THE MACHINE

The machine will not run.
The machine is noisy.
The brush warning light
illuminates.
The machine is vibrating
excessively.
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700
Cause
The machine may not have
any power.
The power cord may be
damaged.
The pad is worn or dirty.
The main switch is defective.
The circuit breaker is defective.
The motor is defective.
The bearings are dry.
The belt is slipping.
The carbon brushes need
replacing.
The pad is not installed
correctly.
The pad is worn or damaged.
Action
Make sure the machine is connected to
the correct voltage and frequency and
that all connections are tight or,
Make sure the machine is plugged in.
Contact an authorized service person
Clean the pad. If the pad is worn, replace it.
Contact an authorized service person.
Contact an authorized service person.
Return to service center.
Grease the bearings or return to service
center.
Re-tension the drive belt.
Contact an authorized service person.
Remove the pad. Install the pad correctly.
Center the pad properly.
Install a new pad.
Page -9 -