Clarke 6460230 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke 6460230에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6460230 17 페이지. 85 mm plunge saw

SAW SAFETY WARNINGS

a. Keep hands away from cutting area and the blade. If both hands are

holding the saw, they cannot be cut by the blade.

b. Do not reach underneath the workpiece. The guard cannot protect you

from the blade below the workpiece.

c. Adjust the cutting depth to the thickness of the workpiece. Less than a full

tooth of the blade teeth should be visible below the workpiece.

d. Never hold the piece being cut in your hands or across your leg. Secure the

workpiece to a stable platform. It is important to support the work properly

to minimise body exposure, blade binding, or loss of control.

e. Hold the power tool by insulated gripping surfaces, when performing an

operation where the cutting tool may contact hidden wiring or its own cord.

Contact with a "live" wire will also make exposed metal parts of the power

tool "live" and could give the operator an electric shock.

When ripping, always use a rip fence or straight edge guide. This improves

the accuracy of cut and reduces the chance of blade binding.

g. Always use blades with the correct size and shape of arbor holes. Blades

that do not match the mounting hardware of the saw will run eccentrically

causing loss of control.

h. Never use damaged or incorrect blade washers or bolt. The blade washers

and bolt were specially designed for your saw, for optimum performance

and safety of operation.

• Kickback is a sudden reaction to a pinched, bound or misaligned saw

blade, causing an uncontrolled saw to lift up and out of the workpiece

toward the operator.

• When the blade is pinched or bound tightly by the kerf closing down, the

blade stalls and the motor reaction drives the unit rapidly back toward the

operator.

• If the blade becomes twisted or misaligned in the cut, the teeth at the back

edge of the blade can dig into the top surface of the wood causing the

blade to climb out of the kerf and jump back toward the operator.

Kickback is the result of saw misuse and/or incorrect operating procedures or

conditions and can be avoided by taking proper precautions as given below.

a. Maintain a firm grip on the saw and position your arms to resist kickback

forces. Position your body to either side of the blade, but not in line with the

blade. Kickback could cause the saw to jump backwards, but kickback

forces can be controlled by the operator if proper precautions are taken.

b. When the blade is binding, or when interrupting a cut for any reason, release

the trigger and hold the saw motionless in the workpiece until the blade

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]