Clarke CAT32B 운영 및 유지보수 지침 매뉴얼 - 페이지 11

{카테고리_이름} Clarke CAT32B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT32B 16 페이지. High speed sabre saw
Clarke CAT32B에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (16 페이지)

페이지 인쇄

MAINTENANCE

WARNING! MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR

SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

DAILY

• Drain water from the compressor

air tank and air-line.

• Pour a few drops of CLARKE air

line oil** into the air inlet. This

should be carried out regardless

of whether or not an air line

lubricator is used. If a lubricator is

not used, this procedure should

be repeated after every two to

three hours of use.

WEEKLY

• Check the air inlet screen filter shown in Fig 4 and clean if necessary.

CLEANING

• Keep the body of the tool clean and free from debris. Grit or gum deposits

in the tool may reduce efficiency.

• After extensive use, remove the inlet screen filter and flush out the

mechanism with gum solvent oil or an equal mixture of SAE No10 oil and

paraffin. Allow to dry before use.

SERVICE AND REPAIR

• Any major servicing and repairs should be carried out by your local

CLARKE dealer or a qualified service technician.

PERFORMANCE

Please note that factors other than the tool may effect its operation and

efficiency such as reduced compressor output, excessive drain on the airline,

moisture, or restrictions in the line, or the use of connectors of improper size or

poor condition which will reduce air supply.

**Clarke Airline Oil is available from your CLARKE dealer: part no 3050825.

Parts & Service: 020 8988 7400/E-mail: [email protected] or [email protected]

Air Inlet Screen

Filter (located

here)