Clarke CAT32B 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke CAT32B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT32B 16 페이지. High speed sabre saw
Clarke CAT32B에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (16 페이지)

페이지 인쇄

OPERATION

1. Slide the safety lock forward.

2. Squeeze the trigger

• Allow the saw to reach full speed

before use.

3. Releaase the trigger to stop the

saw. When the blade has

stopped remove it from the

workpiece.

4. Release the trigger to stop the

tool.

5. Always ensure the tool has stopped before putting it down.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air pressure released.

2. Once the pressure has been released, disconnect the air supply hose from

the tool.

STORAGE

1. Store the tool safely in its box in a dry, secure environment.

2. When storing, ensure the blanking plug is replaced on the airline

connector once the airline has been disconnected.

3. If the tool is not to be used for longer than 24 hours, run a few drops of

CLARKE airline oil into the air inlet and run the tool for a few seconds to

ensure that the oil has been well distributed throughout the tool.

Parts & Service: 020 8988 7400/E-mail: [email protected] or [email protected]

SAFETY LOCK

TRIGGER