Clarke CSS 400 운영 및 유지보수 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CSS 400에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSS 400 14 페이지. 400mm (16") scroll saw

4. BLADE INSTALLATION / RENEWAL

4.1 Standard Blade (with end pins)

4.1.1 Before installing or removing blades, turn OFF the saw and disconnect it from the

supply. Remove the blade as described in 2. Blade Holder Alignment, above.

NOTE:

Whilst the blade is out of the housings, look at the blade housings closely. You will observe that the blade slots

and pin recesses are made so you can position the blade for cutting from the front, or from the side (see figs.

2 & 3). Cutting from the side is necessary when your workpiece is over 16" long.

IMPORTANT: Side cutting can only be performed when the bevel is set at 0

4.1.2 With the blade teeth pointing DOWNWARDS, slot the new blade into the lower

housing so that the pins on the end of the blade, engage in the recess in the

housing. Holding the blade firmly, apply downward pressure to the upper arm,

whilst slotting the upper end of the blade into the slot in the upper housing,

again, making sure the blade pins correctly engage in the recess in the housing.

4.1.3 Replace the Table Insert, and re-tension to the blade, by turning the tension

knob (17) clockwise until you feel the blade is firm. Check to ensure that the

blade pins are properly seated, top and bottom.

4.2 Plain Blades

A pair of holders is provided allowing the use of plain blades (see fig 5).

In order to install the blades with holders on to the machine, the holders must first be attached, as

follows.

4.2.1 Establish which direction of cut is required. (Normal in-line

or cross cut) This will determine which slots in the holder,

the ends of the blades are to be inserted.

The holder is provided with two slots, at right angles to each

other, and one, hex. socket head grub screw, used for

securing the end of the blade in the slot. It will be necessary

to remove the grub screw from the tapped hole in one

slot, and replace it in the tapped hole in the slot you intend

to use. (Fig. 5 shows a blade prepared for normal 'in line'

cutting).

4.2.2 Remove the side cover (2) by removing the 3 screws securing it

4.2.3 With the two blade holders secured to the blade, and the table insert removed,

lower one end of the blade through the access hole in the table.

Ensure the blades' teeth point DOWNWARDS and FORWARDS. Slot the holder

over the lip on the end of the lower housing, and, applying downward pressure

on the upper arm, slot the upper holder over the lip on the upper housing.

NOTE: Easy access to the lower housing is provided when the side cover is removed.

4.2.4. Replace the table insert, and the side cover, and re-tension the blade by turning

the blade tension knob (17) two full turns clockwise.

Fig. 5