Clarke CSS 400 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CSS 400에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSS 400 14 페이지. 400mm (16") scroll saw

PRINCIPAL PARTS OF THE SCROLL SAW

ASSEMBLY

(Numbers in brackets refer to the item numbers in the Parts List)

Your Scroll Saw is fully assembled, except for the Blade Guard, and the Air tube. To attach these

components, proceed as follows:

Line up the holes in the blade guard (33) and that in the air tube bracket (83), with the hole in the

end of the upper arm, and insert the bolt (90). Note that the air tube bracket should lie between

the blade guard and the upper arm. Thread on the washer and nut and tighten sufficiently so

that the guard is firm but capable of pivoting. Do not over tighten.

Plan your installation. Ensure adequate space is available, with good lighting and ventilation,

and an adequate electrical supply is close at hand.

1. MOUNTING

Your Scroll Saw is provided with 3 mounting holes, and it is strongly recommended that you mount

the machine on a solid surface. A pad between the saw and the workbench is further

recommended. The best dimensions being - 24" x 12" x ½". Ensure you use flat washers between

the bolt head and the mounting hole, and do not over tighten the bolts.

Fig. 1