Clarke Metalworker CBS45MD 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Clarke Metalworker CBS45MD에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Metalworker CBS45MD 19 페이지. 6” (152mm) bandsaw

Electrical Connections

Connect the mains lead to a standard 230V (50Hz) electrical supply through an

approved 13Amp BS1363 plug, or a suitably fused isolator switch.

WARNING!

IMPORTANT: The wires in the mains lead are coloured in accordance with the

following code:

Green & Yellow

As the colours of the flexible cord of this appliance may not correspond with the

coloured markings identifying terminals in your plug proceed as follows:

•

Connect GREEN & YELLOW coloured cord to plug terminal marked with a letter

E or Earth symbol "

•

Connect BROWN coloured cord to plug terminal marked with a letter L or

coloured RED

•

Connect BLUE coloured cord to plug terminal marked with a letter N or coloured

BLACK

IMPORTANT: If this appliance is fitted with a plug which is moulded on to the

electric cable (i.e. non- re-wireable) please note:

The plug must be thrown away if it is cut from the electric cable. There is a

danger of electric shock if it is subsequently inserted into a socket outlet.

Never use the plug without the fuse cover fitted.

Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code).

Replacement fuse covers can be obtained from your local dealer or most

electrical stockists.

Fuse Rating

The fuse in the plug must be replaced with one of the same rating (13 amps)

and this replacement must be ASTA approved to BS1362.

IMPORTANT: If in any doubt, do not attempt any electrical repair yourself. Consult

a qualified technician

This Appliance must be Earthed!

- Earth

Blue

- Neutral

Brown

- Live

"or coloured GREEN or GREEN & YELLOW.