Clarke Woodworker CBS12WV 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Clarke Woodworker CBS12WV에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CBS12WV 16 페이지. 305mm (12”) portable bandsaw

Fig. (1) Main Components

Front Cover

Front Cover Securing Knob (x4)

Rip Fence/ Mitre Gauge

Table Set Screw

Control Panel (ON/OFF)

Speed Control Knob

(1) Attach the Feet

1. Unscrew the fours securing knobs (2) and remove the front cover. (see WARNING above)

2. Attach the feet (12) to the underside of the machine using the nuts and screws

supplied, two for each foot (13, Fig.2).

3. Replace the front cover.

(2) Attach the Table

1. Attach the table tilt bracket (19) to the underside of the table, using the four

screws and nuts supplied, as shown in fig. 3.

2. Remove the table insert (7, Fig. 1) and the counter sunk screw (4, Fig. 1) from the

table slot. (This set screw locks the two sides of the slot together, preventing the

table from flexing during use.)

3. Place the table into position from the motor side of the saw, taking care when

passing the blade through the slot, then secure the table using the washers and

adjusting knobs (18) supplied.

4. Replace the set screw (4, Fig. 1) , and fit the table insert (7, Fig. 1).

(Ref: fig 1)

(Ref: fig 3)

Table Insert

Blade Tensioning Screw

Blade Guard

Upper Blade Guide

Dust Extraction Port

Feet