Clarke WOODWORKER CBS250 운영 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke WOODWORKER CBS250에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke WOODWORKER CBS250 20 페이지. 45 mm (10”) bandsaw & stand
Clarke WOODWORKER CBS250에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (13 페이지)

페이지 인쇄

ASSEMBLY

Stand

(Refer to Fig.2)

Assemble sub assy x 2, see fig. 3.

Parts required per assy, 2 legs (L), 1 short beam (H), 1 short

cross member (D), and 8 short round head screws nuts and

washers.

Do not tighten nuts at this stage.

NOTE: Beams and cross members fit inside the legs. Screws are fitted

from the outside with washers and nuts on the inside.

Connect sub assy's together using 2 long cross members (E),

2 long beam's (G), and 8 short round head screws with nuts

and washers, 8 short hex head bolts with washers and nuts,

Do not tighten nuts at this stage.

NOTE: Long beams are fitted on top of short beam's see Fig .4. Hex head

bolts are fitted from the top with washers and nuts on the underside.

Invert the stand and push on the rubber feet.

Turn stand over onto it's feet again and only when

satisfied that it is completely stable, fully tighten all nuts.

Mounting the machine

With assistance, carefully lift the machine on to the stand.

Line up the corner holes and secure the machine to

the stand using, 4 long hex head bolts, from the top,

with washers and nuts on the underside. Fit all four

bolts before finally tightening all nuts, progressively,

taking care not to overtighten.

Manouvre the table (M) carefully so that the the

blade passes through the slot in the table, and

mount the table on to the trunnion - see Fig.5,

Insert the table securing screws and position the

table so that the saw blade runs in the centre of

the table insert. When satisfied, tighten the screws

securely.

Setting The Table Square With The Sawblade

Set the table square to the sawblade by slackening the

lock knob, shown in Fig.6, then adjusting the table so that

the pointer lines up with the '0' position on the scale.

NOTE: The table can be tilted up to 45° to the sawblade.

To tilt the table, slacken the lock knob (Fig.6), tilt the table

to the desired angle as indicated on the scale then retighten

the lock knob. It is recommended to check the correct

angle setting, by making trial cuts in scrap pieces of wood.

Trunnion

Fig.3

Fig.4

Fig.5

Fig.6