Clarke woodworker CMS10 6501305 운영 및 유지 관리 지침 - 페이지 10

{카테고리_이름} Clarke woodworker CMS10 6501305에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke woodworker CMS10 6501305 20 페이지. 10” compound mitre saw

ASSEMBLY and INSTALLATION.

The saw is fully assembled and adjusted at the factory. On receipt inspect the

machine to ensure that all parts are accounted for and that no damage was

incurred during transit.

Loose items are:

1 x socket spanner:

1 x spare blade bore reducer bush.

1 x dust bag

1 x rear support with nut and bolt

Any deficiency or damage should be reported to your CLARKE dealer immediately.

Mount the machine on a firm solid base that will not move under load. Ensure there

is an appropriate electrical supply, and adequate lighting, so that you will not be

working in your own shadow.

Four holes are provided, one at each corner of the base, so that the machine may

be bolted permanently to a workbench for added stability, using 8mm bolts (not

provided). Alternatively it may be bolted to a piece of plywood with a thickness of

16mm (5/8").

If not bolted to a workbench, the rear support must be fitted - see Figs 1 and 2. A

single bolt secures the support to the rear of the base housing.

The Cutting Head is locked in its lower position for transit purposes. To release it, pull

out the Head Locking Pin - see Fig 3 (It may be necessary to apply slight downward

pressure to the head in order to do so), and allow the head to rise to its upper

position gently, under control.

The head will lock in its upper position, and is prevented from being lowered until

the Safety Lever (see Fig 2) is pushed to one side.

OPERATION.

A. Cross Cutting.

Set the table at 0 degrees as shown on the scale at the front of the table. To do this,

firstly unscrew the large table knob a few turns, then press down on the table locking

lever - see Fig.3, and turn the table, using the large table knob, until it clicks into place.

To secure the table, screw in the table knob fully.

Set the work in place with the left end firmly clamped against the table and back

fence.

It is important to ensure that one end of the workpiece is completely free to move

i.e. NOT clamped or held in any way. This will normally be the off-cut or shorter end.

(Ref Fig.4)

(at 90°)

1 x spare set of carbon brushes.

1 x plastic 90/45

1 x work clamp with support bar

2 x work supports

template.