Clarke woodworker CMS10 6501305 운영 및 유지 관리 지침 - 페이지 9

{카테고리_이름} Clarke woodworker CMS10 6501305에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke woodworker CMS10 6501305 20 페이지. 10” compound mitre saw

FEATURES

As its' name implies, the machine is a Bevel/Mitre Saw, capable of straight cross

cutting, and cutting bevels and mitres, or a combination of the two.

The main arm, or Cutting Head, carries the motor and the tungsten carbide saw

blade. The head, complete with table, is allowed to swivel to produce mitre cuts

and the head may also tilt to the left to produce bevel cuts. A combination of

swivelling head and tilting head will also produce compound mitres

The table, with head, is designed to swivel up to 45 degrees in either direction and

is provided with positive stops at 90, 60, 45 and 22.5 degrees.

The maximum sizes of wood that may be cut in any of these processes is given in

the Specifications on page 3.

A dust extraction outlet is provided at the rear of the machine, on to which the dust

bag (supplied) is fitted. If necessary, hose from a vacuum cleaner may be attached

to provide fast and efficient removal of sawdust. The vacuum cleaner may be

used continuously or intermittently depending upon your requirements.

The blade drive shaft has a 16mm diameter. A 60T TCT blade is provided with a

bore of 30mm. A reducer bush is therefore used, and one spare is provided.

This saw is not designed for cutting metal, plastics or masonry.

To transport the saw, simply pick it up using the carry handle on top of the head.

NOTE: The cutting head must be in its lower position as shown below, locked in

position using the Head Locking Pin.

A saw blade spindle locking lever is provided - see Fig.3, used in order to remove

the saw blade. WARNING! NEVER touch this lever when the saw is operating.

Fig.3