Clarke woodworker CMS10 6501305 Інструкція з експлуатації та обслуговування - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Пила. Clarke woodworker CMS10 6501305. Clarke woodworker CMS10 6501305 20 сторінок. 10” compound mitre saw
Друкувати сторінку
FEATURES
As its' name implies, the machine is a Bevel/Mitre Saw, capable of straight cross
cutting, and cutting bevels and mitres, or a combination of the two.
The main arm, or Cutting Head, carries the motor and the tungsten carbide saw
blade. The head, complete with table, is allowed to swivel to produce mitre cuts
and the head may also tilt to the left to produce bevel cuts. A combination of
swivelling head and tilting head will also produce compound mitres
The table, with head, is designed to swivel up to 45 degrees in either direction and
is provided with positive stops at 90, 60, 45 and 22.5 degrees.
The maximum sizes of wood that may be cut in any of these processes is given in
the Specifications on page 3.
A dust extraction outlet is provided at the rear of the machine, on to which the dust
bag (supplied) is fitted. If necessary, hose from a vacuum cleaner may be attached
to provide fast and efficient removal of sawdust. The vacuum cleaner may be
used continuously or intermittently depending upon your requirements.
The blade drive shaft has a 16mm diameter. A 60T TCT blade is provided with a
bore of 30mm. A reducer bush is therefore used, and one spare is provided.
This saw is not designed for cutting metal, plastics or masonry.
To transport the saw, simply pick it up using the carry handle on top of the head.
NOTE: The cutting head must be in its lower position as shown below, locked in
position using the Head Locking Pin.
A saw blade spindle locking lever is provided - see Fig.3, used in order to remove
the saw blade. WARNING! NEVER touch this lever when the saw is operating.
Fig.3
9