Clarke Woodworker CMS251 운영 및 유지보수 매뉴얼 - 페이지 15

{카테고리_이름} Clarke Woodworker CMS251에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CMS251 19 페이지. Compound mitre saw

3. Renewing Motor Brushes

Eventually, the motors' carbon brushes will need replacing. This task may be carried

out quickly and easily as follows.

Remove the two cross head

screws, securing the motors'

end cover, and pull off the

cover.

Disconnect the spade

connector, shown in Fig. 15,

then pull out the brush carrier,

complete with brush, as shown

in Fig. 14.

The cable is located on a

plastic peg, shown in Fig. 15

and will simply pull away as you

remove the brush.

Replace in reverse order.

To locate the brush carrier,

(which houses the brush),

correctly, position the brush so

that it bears on the

commutator then push down

gently and evenly on the brush

carrier so that the carrier can

be pushed on to its runners,

with the brush sitting snugly on

the commutator.

Ensure the spade

connector is secure and the

cable is mounted on the

locating peg before replacing

the end cover.

Fig.14

Fig.15