Clarke Woodworker CMS251 운영 및 유지보수 매뉴얼 - 페이지 13

{카테고리_이름} Clarke Woodworker CMS251에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CMS251 19 페이지. Compound mitre saw

MAINTENANCE

1. General

User maintenance is limited to changing the saw blade when necessary, renewing

the motors' carbon brushes, maintaining adjustments, and ensuring that after use,

any sawdust or wood chips are cleaned away, with a low pressure air line or

brush, paying particular attention to the motor air vents which should be kept

clear at all times.

Should the motor not function normally, it is possible that it has become clogged

with saw dust, in which case, it will be necessary to disassemble the motor in order

to clean the various components. Contact your CLARKE dealer for advice.

2. Changing the Saw Blade

IMPORTANT: Exercise extreme care when

handling the saw blade. The tips are

extremely sharp, and careless handling

could result in severe personal injury.

With the machine disconnected from the

mains supply, and the Cutting Head in

the raised position, remove the Blade

Guard Arm Link Pin, arrowed in Fig. 8, and

retain.

Slacken the Blade Guard Bracket

securing screw, shown at 'A' in Fig. 9, and

REMOVE the screw 'B'. (Leave Screw 'A'

in place.)

This will allow the Lower Blade Guard to

be removed completely.

Take great care from this point, not to

come into contact with the saw blade

teeth.

Remove the two screws securing the left

hand lower plastic guard, arrowed in Fig.

10, and remove the guard.

Fig.8

Fig.9

Fig.10