Clarke Woodworker CMS251 운영 및 유지보수 매뉴얼 - 페이지 12

{카테고리_이름} Clarke Woodworker CMS251에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CMS251 19 페이지. Compound mitre saw

C. Straight Bevel Cutting

As with Mitre Cutting, this is a cross cutting operation, except that the blade is not

perpendicular to the table (see illustration)

Ensure the table is set so that

the table pointer lines up

with the zero on the scale on

the bed.

Slacken off the Bevel

Locking Knob (N), and swing

the Head to the side.

Set the head to the required

angle according to the

scale (M).

Lock the head in position by

retightening

the

Locking Knob.

The 45

adjuster is factory set so that when the Head is tilted to its fullest extent the

blade will cut 45

The procedure for cutting is the same as that for cross cutting.

If the angle is critical, use a small angle gauge on the table to check the angle of

the blade to table. Assistance will be required to carry out this task.

D. Compound Mitre and Bevel Cutting.

Having determined the angles you require, first set the Bevel angle, using the

procedure described above, and then the Mitre angle.

The procedure for cutting is the same as that for cross cutting.

Bevel

bevel.

Fig.6

Fig.7