Clarke Woodworker CMS251 Manual de operação e manutenção - Página 12
Procurar online ou descarregar pdf Manual de operação e manutenção para Serra Clarke Woodworker CMS251. Clarke Woodworker CMS251 19 páginas. Compound mitre saw
Imprimir página
C. Straight Bevel Cutting
As with Mitre Cutting, this is a cross cutting operation, except that the blade is not
perpendicular to the table (see illustration)
Ensure the table is set so that
the table pointer lines up
with the zero on the scale on
the bed.
Slacken off the Bevel
Locking Knob (N), and swing
the Head to the side.
Set the head to the required
angle according to the
scale (M).
Lock the head in position by
retightening
the
Locking Knob.
The 45
O
adjuster is factory set so that when the Head is tilted to its fullest extent the
blade will cut 45
The procedure for cutting is the same as that for cross cutting.
If the angle is critical, use a small angle gauge on the table to check the angle of
the blade to table. Assistance will be required to carry out this task.
D. Compound Mitre and Bevel Cutting.
Having determined the angles you require, first set the Bevel angle, using the
procedure described above, and then the Mitre angle.
The procedure for cutting is the same as that for cross cutting.
Bevel
O
bevel.
12
Fig.6
Fig.7