Clarke Woodworker CSS400B 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke Woodworker CSS400B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CSS400B 16 페이지. 400mm (16") scroll saw

PRINCIPAL PARTS OF THE SCROLL SAW

Your Scroll Saw is fully assembled, except for the Blade Guard, and the Air tube. To attach these

components, proceed as follows:

Position the Blade guard and Air Tube in the manner

shown in Fig1a, i.e. with the Air Tube Bracket on the

inside of the Blade Guard, at the LEFT side of the guard

- looking at the front. (See also Fig.1 above)

Slide the pivot bolt through the slotted holes in the

Guard and Bracket, then through the mounting on

top of the Upper Arm. Thread on the Flat Washer and

M6 Nyloc nut and nip up sufficient so as not to crush

the Guard, but to allow it to pivot easily.

NOTE that the bolt head should sit snugly, and bottom

out in the slotted hole in the blade guard (arrowed in

Fig. 1a). This prevents the bolt from turning when

threading on the Nyloc nut.

Plan your installation. Ensure adequate space is available, with good lighting and ventilation,

and an adequate electrical supply is close at hand.

Your Scroll Saw is provided with 3 mounting holes, and it is strongly recommended that you mount

the machine on a solid surface. A pad between the saw and the workbench is further

recommended. The best dimensions being - 21" x 12" x ½". Ensure you use flat washers between

the bolt head and the mounting hole, and do not over tighten the bolts.

Fig. 1

Fig. 1a