Clarke Woodworker CSS400B Handleiding voor gebruik en onderhoud - Pagina 7
Blader online of download pdf Handleiding voor gebruik en onderhoud voor {categorie_naam} Clarke Woodworker CSS400B. Clarke Woodworker CSS400B 16 pagina's. 400mm (16") scroll saw
Pagina afdrukken
PRINCIPAL PARTS OF THE SCROLL SAW
ASSEMBLY
Your Scroll Saw is fully assembled, except for the Blade Guard, and the Air tube. To attach these
components, proceed as follows:
Position the Blade guard and Air Tube in the manner
shown in Fig1a, i.e. with the Air Tube Bracket on the
inside of the Blade Guard, at the LEFT side of the guard
- looking at the front. (See also Fig.1 above)
Slide the pivot bolt through the slotted holes in the
Guard and Bracket, then through the mounting on
top of the Upper Arm. Thread on the Flat Washer and
M6 Nyloc nut and nip up sufficient so as not to crush
the Guard, but to allow it to pivot easily.
NOTE that the bolt head should sit snugly, and bottom
out in the slotted hole in the blade guard (arrowed in
Fig. 1a). This prevents the bolt from turning when
threading on the Nyloc nut.
INSTALLATION
Plan your installation. Ensure adequate space is available, with good lighting and ventilation,
and an adequate electrical supply is close at hand.
1. MOUNTING
Your Scroll Saw is provided with 3 mounting holes, and it is strongly recommended that you mount
the machine on a solid surface. A pad between the saw and the workbench is further
recommended. The best dimensions being - 21" x 12" x ½". Ensure you use flat washers between
the bolt head and the mounting hole, and do not over tighten the bolts.
7
Fig. 1
Fig. 1a