Clarke 6920019 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke 6920019에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6920019 17 페이지. Twin head gas radiant heater

INSTALLATION

UNPACKING

Remove the heater from the carton and remove all protective material used

for shipment. Check the heater for possible shipping damage. Should any

damage be apparent, please notify your CLARKE dealer immediately.

ASSEMBLING THE SUPPORT STAND

1. Connect the tube base section to the

upper tube support section and secure

with the wing nut supplied.

2. Connect the support bracket to the

tube base section as shown and secure

with the wing nuts supplied.

Although a 'tip-over' switch is fitted, the heater and propane gas bottle must

both be located on a hard, level surface to minimize the risk of accidental

tipping. The propane gas bottle should be adequately restrained if needed.

Only operate this heater with the supply bottle in the upright position.

This heater must only be used in locations where the potential for damage to

the heater or personal injury (burns), is reduced to a minimum.

The heater must be located where it will not be exposed directly to rain and/or

dripping water.

Use of this heater in a drafty area reduces its efficiency. Wherever possible,

operate in a draft free area.

The heater must always be directed away from the propane gas bottle.

Position the heater at a safe distance of 1 metre from combustible materials.

The heater must not be used on floors covered in combustible materials.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]