Clarke 6920019 Інструкція з експлуатації та технічного обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Обігрівач Clarke 6920019. Clarke 6920019 17 сторінок. Twin head gas radiant heater
Друкувати сторінку
INSTALLATION
UNPACKING
Remove the heater from the carton and remove all protective material used
for shipment. Check the heater for possible shipping damage. Should any
damage be apparent, please notify your CLARKE dealer immediately.
ASSEMBLING THE SUPPORT STAND
1. Connect the tube base section to the
upper tube support section and secure
with the wing nut supplied.
2. Connect the support bracket to the
tube base section as shown and secure
with the wing nuts supplied.
LOCATING THE HEATER
Although a 'tip-over' switch is fitted, the heater and propane gas bottle must
both be located on a hard, level surface to minimize the risk of accidental
tipping. The propane gas bottle should be adequately restrained if needed.
Only operate this heater with the supply bottle in the upright position.
This heater must only be used in locations where the potential for damage to
the heater or personal injury (burns), is reduced to a minimum.
The heater must be located where it will not be exposed directly to rain and/or
dripping water.
Use of this heater in a drafty area reduces its efficiency. Wherever possible,
operate in a draft free area.
The heater must always be directed away from the propane gas bottle.
Position the heater at a safe distance of 1 metre from combustible materials.
The heater must not be used on floors covered in combustible materials.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7