Clarke 6925117 운영 및 유지 관리 지침 - 페이지 7

{카테고리_이름} Clarke 6925117에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6925117 9 페이지. Multi-directional quartz halogen infra red heater

MAINTENANCE

Allow the heater to cool down for at least 15 minutes after switching off, before

performing any maintenance tasks.

REPLACING THE HEATING LAMPS

NEVER handle the heater lamps with bare hands, ALWAYS handle using either a soft

clean glove, or a piece of soft clean cloth wrapped around the lamp.

Before attempting to fit/replace heater lamps, ensure the heater is switched off and

isolated from the main electrical supply by removing the plug from the socket. Also

ensure the heater is in an upright position.

Loosen and remove the two pozidrive screws securing the chromed guard, remove

the guard and store removed parts safely.

To remove lamp, grasp lamp and gently but firmly push it towards one end of the

heater, the lamp holders are sprung loaded and will allow the lamp to move

sufficiently in order to clear the opposite holder.

Remove the lamp and dispose of according to local regulations.

Fit new halogen lamp in reverse order, repeat both procedures for second lamp.

Replace the guard using the screws removed earlier.

The heater is now ready for use again, and may be plugged in and switched on.

IF IN ANY DOUBT, ALWAYS CONSULT A QUALIFIED TECHNICIAN. DO NOT

CLEANING

•

Disconnect from the mains supply, remove the guard and wipe the reflectors

with a clean dry cloth. DO NOT use abrasive cleaners. Take care NOT to touch

the tube with your fingers.

•

Inspect the mains cable for damage. Heat damage will cause the cable to stiffen

and crack. If this is found, have the cable replaced (refer to your CLARKE dealer),

check cable routing and ensure it is well away from the heat source.

PARTS & SERVICE

PARTS:

SERVICE:

IMPORTANT

CARRY OUT ANY REPAIRS YOURSELF.

PARTS & SERVICE TEL: 020 8988 7400

e-mail as follows: