Clarke 6925117 Instruções de funcionamento e manutenção - Página 7
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Aquecedor Clarke 6925117. Clarke 6925117 9 páginas. Multi-directional quartz halogen infra red heater
Imprimir página
MAINTENANCE
Allow the heater to cool down for at least 15 minutes after switching off, before
performing any maintenance tasks.
REPLACING THE HEATING LAMPS
NEVER handle the heater lamps with bare hands, ALWAYS handle using either a soft
clean glove, or a piece of soft clean cloth wrapped around the lamp.
Before attempting to fit/replace heater lamps, ensure the heater is switched off and
isolated from the main electrical supply by removing the plug from the socket. Also
ensure the heater is in an upright position.
1.
Loosen and remove the two pozidrive screws securing the chromed guard, remove
the guard and store removed parts safely.
2.
To remove lamp, grasp lamp and gently but firmly push it towards one end of the
heater, the lamp holders are sprung loaded and will allow the lamp to move
sufficiently in order to clear the opposite holder.
3.
Remove the lamp and dispose of according to local regulations.
4.
Fit new halogen lamp in reverse order, repeat both procedures for second lamp.
5.
Replace the guard using the screws removed earlier.
The heater is now ready for use again, and may be plugged in and switched on.
IF IN ANY DOUBT, ALWAYS CONSULT A QUALIFIED TECHNICIAN. DO NOT
CLEANING
•
Disconnect from the mains supply, remove the guard and wipe the reflectors
with a clean dry cloth. DO NOT use abrasive cleaners. Take care NOT to touch
the tube with your fingers.
•
Inspect the mains cable for damage. Heat damage will cause the cable to stiffen
and crack. If this is found, have the cable replaced (refer to your CLARKE dealer),
check cable routing and ensure it is well away from the heat source.
PARTS & SERVICE
PARTS:
SERVICE:
IMPORTANT
CARRY OUT ANY REPAIRS YOURSELF.
PARTS & SERVICE TEL: 020 8988 7400
or
e-mail as follows:
7