Clarke CONTRACTOR DEVIL371PD 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke CONTRACTOR DEVIL371PD에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR DEVIL371PD 17 페이지. Devil quartz halogen heater

ELECTRICAL CONNECTIONS

DEVIL 371PD (110V) UNIT

The 110V model is fitted with a 32 Amp, three pin industrial plug to EN 60309

and MUST be connected to a 110 volt, 1 phase 50 Hz supply through a suitably

fused isolator switch.

On no account must a 230V, 13 amp (BS1363) plug be used.

NOTE: If a portable 110V transformer is used, make sure it has a rated

capacity sufficient to take the load of the heater.

If the heater is hard wired into the electrical system, all work must be carried

out in accordance with IEE regulations.

If the plug has to be changed due to damage, a replacement should be

fitted, following the wiring instructions shown below. The old plug must be

disposed of as insertion into a 110v socket could cause an electrical hazard.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE

COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

BLUE = NEUTRAL

If the colours of the wires in the power cable of this product do not correspond

with the markings on the terminals of your plug, proceed as follows.

• The Blue wire must be

connected to the terminal

which is marked N or

Neutral.

• The Brown wire must be

connected to the terminal

which is marked L or Live.

• The Yellow wire must be

connected to the terminal

which is marked E or Earth.

If in any doubt, consult a qualified

electrician. DO NOT attempt any

repairs yourself.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

BROWN = LIVE

YELLOW = EARTH

Plug must be BS60309 approved.

Earth

Neutral

Live