Clarke GRH15 운영 및 유지보수 지침 매뉴얼 - 페이지 11

{카테고리_이름} Clarke GRH15에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke GRH15 17 페이지. Portable gas radiant heater

WARNING: DO NOT FACE THE HEATER ELEMENT WHEN STARTING - ALWAYS

STAND TO ONE SIDE.

NOTE: If a new gas cylinder has been

connected, it may take time

for the gas line to be purged

of air. Press the Piezo electric

button every 10-15 seconds

until it ignites.

3. Alternatively, hold a lit taper to

the burner face while pressing

and holding the control valve

button. After the burner ignites,

keep the button pressed for 12-15

seconds or until the burner stays lit

after releasing the button.

NOTE: In cases where a long run of

gas supply line has been used,

it may be necessary to bleed

trapped air out of the supply

line before lighting. Open the

shut off valve and listen for the

gas passing through the

heater for a few moments

before operating the igniter and attempting to light the heater. New

installations generally require this.

NOTE: When lighting the burner with a taper, light at the bottom of the

screen, not at the nozzle.

SHUTTING OFF THE HEATER

1. Close the propane gas supply cylinder valve.

2. Observe the burner until the flame is extinguished.

3. Close the shut off valve on the heater.

4. DO NOT re-open the propane gas supply cylinder valve before the shut-off

valve is closed.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]